514.001.108 Tyco BG Conventional Callpoint EX II 2 GD

EX II 2 GD Increased safety (EExemd) conventional callpoint

This EX II 2 GD Dust Approved & Increased Safety (EExemd) Conventional Break Glass Manual Alarm Call Point is fitted with a 470 ohm Alarm Level Resistor and a 4K7 ohm EOL Resistor for use with Tyco Conventional Detection Circuits including the DIM800 and DDM800 MX Modules.

Key Features:

- Conventional I.S. system

- Suitable for worst case (EEx ia IIC T5)

- High Performance Optical (HPO) smoke detector

- Compatible with S231i+ flame detector

- Compatible I.S. callpoint

- Suitable for use in Zone 0,1,2,20,21& 22

- Polyester Enclosure - light, strong and not subject to corrosion.

- Break Glass.

- Explosion protected EExe (ATEX Approved).

- In line and end of line resistors.

- Red.

- 9 x terminals.

- Lift flap for extra protection against inadvertent operation.

- 1 x changeover switch.

- Captive cover screws.

- No hammer required - the glass is covered by a membrane thus protecting the operator from glass fragments.

- Key operated test facility - simple but secure.

- 2 x M20 bottom cable entries